Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 95)

AT8404 Switching Commands

Page 2 - 59 AT8404 CLI Reference Manual

2.12.17.1 no storm-control unicast all level

This command sets the unicast storm recovery threshold to the default value and disables unicast storm recovery

for all interfaces.

2.12.18 storm-control unicast all rate

Use this command to configure the unicast storm recovery threshold for all interfaces in packets per second. If the

mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface

increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of unicast traffic is limited to

the configured threshold.

2.12.18.1 no storm-control unicast all rate

This command sets the multicast storm recovery threshold to the default value for an interface and disables multicast

storm recovery.

2.12.19 storm-control flowcontrol

This command enables 802.3x flow control for the switch and only applies to full-duplex mode ports.

2.12.19.1 no storm-control flowcontrol

This command disables 802.3x flow control for the switch.

Format no storm-control unicast all level

Mode Global Config

Default 0

Format storm-control unicast all rate <0-33554431>

Mode Global Config

Format no storm-control unicast all rate

Mode Global Config

Note: 802.3x flow control works by pausing a port when the port becomes oversubscribed and dropping

all traffic for small bursts of time during the congestion condition. This can lead to high-priority and/or

network control traffic loss.

Default disabled

Format storm-control flowcontrol

Mode Global Config

Note: This command only applies to full-duplex mode ports.

Format no storm-control flowcontrol

Mode Global Config

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 372 373

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 95