Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 112)

Switching Commands AT8404

AT8404 CLI Reference Manual Page 2 - 76

receive the monitored traffic. Use the mode parameter to enabled the administrative mode of the session. If enabled,

the probe port monitors all the traffic received and transmitted on the physical monitored port.

2.14.1.1 no monitor session

Use this command without optional parameters to remove the monitor session (port monitoring) designation from

the source probe port, the destination monitored port and all VLANs. Once the port is removed from the VLAN, you

must manually add the port to any desired VLANs. Use the source interface <slot/port> parameter or

destination interface <slot/port> to remove the specified interface from the port monitoring session.

Use the mode parameter to disable the administrative mode of the session.

2.14.2 no monitor

This command removes all the source ports and a destination port for the and restores the default value for mirroring

session mode for all the configured sessions.

2.14.3 show monitor session

This command displays the Port monitoring information for a particular mirroring session.

Format monitor session <session-id> {source interface <slot/port> [{rx | tx}]

| destination interface <slot/port> | mode}

Mode Global Config

Note: Since the current version of FASTPATH software only supports one session, if you do not supply

optional parameters, the behavior of this command is similar to the behavior of the no monitor

command.

Format no monitor session <session-id> [{source interface <slot/port> |

destination interface <slot/port> | mode}]

Mode Global Config

Note: This is a stand-alone “no” command. This command does not have a “normal” form.

Default enabled

Format no monitor

Mode Global Config

Note: The <session-id> parameter is an integer value used to identify the session. In the current

version of the software, the <session-id> parameter is always one (1).

Format show monitor session <session-id>

Mode Privileged EXEC

Term Definition

Session ID An integer value used to identify the session. Its value can be anything between 1 and the

maximum number of mirroring sessions allowed on the platform.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 372 373

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 112