Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 31)

AT8404 Using the Command-Line Interface

Page 1 - 5 AT8404 CLI Reference Manual

modules. Additionally, for some show commands, the output fields might change based on the modules included in

the FASTPATH software.

The FASTPATH software suite includes the following modules:

• Switching (Layer 2)

• Quality of Service

• Management (CLI and SNMP)

Not all modules are available for all platforms or software releases.

1.7 Command Modes

The CLI groups commands into modes according to the command function. Each of the command modes supports

specific FASTPATH software commands. The commands in one mode are not available until you switch to that

particular mode, with the exception of the User EXEC mode commands. You can execute the User EXEC mode

commands in the Privileged EXEC mode.

The command prompt changes in each command mode to help you identify the current mode. Table 5 describes

the command modes and the prompts visible in that mode.

Note: The command modes available on your switch depend on the software modules that are installed.

Table 5: CLI Command Modes

Command Mode Prompt Mode Description

User EXEC Switch> Contains a limited set of commands to view

basic system information.

Privileged EXEC Switch# Allows you to issue any EXEC command,

enter the VLAN mode, or enter the Global

Configuration mode.

Global Config Switch (Config)# Groups general setup commands and

permits you to make modifications to the

running configuration.

VLAN Config Switch (Vlan)# Groups all the VLAN commands.

Interface Config Switch (Interface <slot/port>)#

Switch (Interface Loopback <id>)#

Switch (Interface Tunnel <id>)#

Manages the operation of an interface and

provides access to the router interface

configuration commands.

Use this mode to set up a physical port for a

specific logical connection operation.

Line Config Switch (line)# Contains commands to configure outbound

telnet settings and console interface settings.

Policy Map

Config

Switch (Config-policy-map)# Contains the QoS Policy-Map configuration

commands.

Policy Class

Config

Switch (Config-policy-class-map)# Consists of class creation, deletion, and

matching commands. The class match

commands specify Layer 2, Layer 3, and

general match criteria.

Class Map Config Switch (Config-class-map)# Contains the QoS class map configuration

commands for IPv4.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 372 373

Comentários a estes Manuais

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 31

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Kontron AT8404 CLI