Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 309)

AT8404 Management Commands

Page 5 - 33 AT8404 CLI Reference Manual

5.9.3.1 no radius server attribute

The no version of this command disables the NAS-IP-Address attribute global parameter for RADIUS client. When

this parameter is disabled, the RADIUS client does not send the NAS-IP-Address attribute in RADIUS requests.

Example: The following shows an example of the command.

(Switch) (Config) #radius server attribute 4 192.168.37.60

(Switch) (Config) #radius server attribute 4

5.9.4 radius server host

This command configures the IP address or DNS name to use for communicating with the RADIUS server of a

selected server type. While configuring the IP address or DNS name for the authenticating or accounting servers,

you can also configure the port number and server name. If the authenticating and accounting servers are

configured without a name, the command uses the ‘Default_RADIUS_Auth_Server’ and

‘Default_RADIUS_Acct_Server’ as the default names, respectively. The same name can be configured for more

than one authenticating servers and the name should be unique for accounting servers. The RADIUS client allows

the configuration of a maximum 32 authenticating and accounting servers.

If you use the <auth> parameter, the command configures the IP address or hostname to use to connect to a

RADIUS authentication server. You can configure up to 3 servers per RADIUS client. If the maximum number of

configured servers is reached, the command fails until you remove one of the servers by issuing the “no” form of the

command. If you use the optional <port> parameter, the command configures the UDP port number to use when

connecting to the configured RADIUS server. The <port> number range is 1 - 65535, with 1812 being the default

value.

If you use the <acct> token, the command configures the IP address or hostname to use for the RADIUS

accounting server. You can only configure one accounting server. If an accounting server is currently configured,

use the “no” form of the command to remove it from the configuration. The IP address or hostname you specify must

match that of a previously configured accounting server. If you use the optional <port> parameter, the command

configures the UDP port to use when connecting to the RADIUS accounting server. If a <port> is already

configured for the accounting server, the new <port> replaces the previously configured <port>. The <port>

must be a value in the range 0 - 65535, with 1813 being the default.

Format radius server attribute <4> [<ipaddr>]

Mode Global Config

Term Definition

4 NAS-IP-Address attribute to be used in RADIUS requests.

ipaddr The IP address of the server.

Format no radius server attribute <4> [<ipaddr>]

Mode Global Config

Note: To re-configure a RADIUS authentication server to use the default UDP <port>, set the <port>

parameter to 1812.

Note: To re-configure a RADIUS accounting server to use the default UDP <port>, set the <port>

parameter to 1813.

1 2 ... 304 305 306 307 308 309 310 311 312 313 314 ... 372 373

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 309