Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 307)

AT8404 Management Commands

Page 5 - 31 AT8404 CLI Reference Manual

5.8.30 enable (filter)

This command enables the filter rule..

5.8.31 disable (filter)

This command disables the filter rule. The rule is not deleted. The rule is disabled by default if a new rule is

generated..

5.8.32 ipmb (filter)

This command specifies the site for which a trap should be sent. The site is either ‘all’ for all sites (default) or ‘local’

for the local site or an IPMB address for remote sites. The IPMB address can be either specified decimal or

hexadecimal (prefix ‘0x’)..

5.8.33 type (filter)

This command specifies the sensor type for which a trap should be sent. The type is either ‘all’ for all types (default)

or a pre-defined sensor type (by related name) or a value (decimal or hexadecimal)..

5.8.34 status (filter)

This command specifies the state for which a trap should be sent. Relevant only for analog sensors. The state is

either ‘all’ for all states (default) or a special state..

5.8.35 assert (filter)

This command specifies if a trap should be sent for assert or deassert event. This can be used for discrete and

analog sensors. For analog sensors assert means going low for lower thresholds and going high for upper

thresholds. The assertion is either ‘all’ for all assertion states (default) or a special assertion state..

Format enable

Mode IPMI-filter Exec

Format disable

Mode IPMI-filter Exec

Format ipmb {all | local | <ipmb-address>}

Mode IPMI-filter Exec

Format type {all | analog | discrete | temperature | voltage | current | fan |

<value>}

Mode IPMI-filter Exec

Format status {all | non-critical | critical | non-recoverable}

Mode IPMI-filter Exec

Format assert {all | asserted | deasserted}

Mode IPMI-filter Exec

1 2 ... 302 303 304 305 306 307 308 309 310 311 312 ... 372 373

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 307