
AT8404 Quality of Service (QoS) Commands
Page 3 - 33 AT8404 CLI Reference Manual
3.8.5 ip access-group
This command either attaches a specific IP ACL identified by <accesslistnumber> to an interface or associates
with a VLAN ID in a given direction.
An optional sequence number may be specified to indicate the order of this IP access list relative to other IP access
lists already assigned to this interface and direction. A lower number indicates higher precedence order. If a
sequence number is already in use for this interface and direction, the specified access list replaces the currently
attached IP access list using that sequence number. If the sequence number is not specified for this command, a
sequence number that is one greater than the highest sequence number currently in use for this interface and
direction is used.
3.8.5.1 no ip access-group
This command removes a specified IP ACL from an interface.
3.8.6 acl-trapflags
This command enables the ACL trap mode.
3.8.6.1 no acl-trapflags
This command disables the ACL trap mode.
Format {deny | permit} {every | {{icmp | igmp | ip | tcp | udp | <number>} <srcip>
<srcmask>[{eq {<portkey> | <0-65535>} <dstip> <dstmask> [{eq
{<portkey>| <0-65535>}] [precedence <precedence> | tos <tos> <tosmask> |
dscp <dscp>] [log] [assign-queue <queue-id>] [{mirror | redirect} <unit/
slot/port>]
Mode Ipv4-Access-List Config
Default none
Format ip access-group <accesslistnumber> [vlan <vlan-id>] in [sequence <1-
4294967295>]
Modes • Interface Config
• Global Config
Default none
Format no ip access-group <accesslistnumber> [vlan <vlan-id>] in
Mode • Interface Config
• Global Config
Default disabled
Format acl-trapflags
Mode Global Config
Format no acl-trapflags
Mode Global Config
Comentários a estes Manuais