
AT8404 Switching Commands
Page 2 - 55 AT8404 CLI Reference Manual
2.12.7.1 no storm-control multicast
This command disables multicast storm recovery mode for an interface.
2.12.8 storm-control multicast level
This command configures the multicast storm recovery threshold for an interface as a percentage of link speed and
enables multicast storm recovery mode. If the mode is enabled, multicast storm recovery is active, and if the rate of
L2 multicast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped.
Therefore, the rate of multicast traffic will be limited to the configured threshold.
2.12.8.1 no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an interface and disables multicast
storm recovery.
2.12.9 storm-control multicast rate
Use this command to configure the multicast storm recovery threshold for an interface in packets per second. If the
mode is enabled, multicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of multicast traffic is limited to
the configured threshold.
2.12.9.1 no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for an interface and disables multicast
storm recovery.
Format storm-control multicast
Mode Interface Config
Format no storm-control multicast
Mode Interface Config
Default 5
Format storm-control multicast level <0-100>
Mode Interface Config
Format no storm-control multicast level <0-100>
Mode Interface Config
Default 0
Format storm-control multicast rate <0-33554431>
Mode Interface Config
Format no storm-control multicast rate
Mode Interface Config
Comentários a estes Manuais