Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 346)

AT8404 FASTPATH log messages

Page B - 13 AT8404 CLI Reference Manual

B.6 Technologies

Table 34: DiffServ Log Messages

Component Message Cause

DiffServ diffserv.c 165: diffServRestore Failed to reset

DiffServ. Recommend resetting device

While attempting to clear the running

configuration an error was encountered in

removing the current settings. This may lead

to an inconsistent state in the system and

resetting is advised.

DiffServ Policy invalid for service intf: "policy name,

intIfNum x, direction y

The DiffServ policy definition is not compatible

with the capabilities of the interface specified.

Check the platform release notes for

information on configuration limitations.

Table 35: Broadcom Error Messages

Component Message Cause

Broadcom Invalid USP unit = x, slot = x, port =x A port was not able to be translated correctly

during the receive.

Broadcom In hapiBroadSystemMacAddress call to

'bcm_l2_addr_add' - FAILED : x

Failed to add an L2 address to the MAC table.

This should only happen when a hash collision

occurs or the table is full.

Broadcom Failed installing mirror action - rest of the

policy applied successfully

A previously configured probe port is not being

used in the policy. The release notes state

that only a single probe port can be configured

Broadcom Policy x does not contain rule x The rule was not added to the policy due to a

discrepancy in the rule count for this specific

policy . Additionally, the message can be

displayed when an old rule is being modified,

but the old rule is not in the policy

Broadcom ERROR: policy x, tmpPolicy x, size x, data x x

x x x x x x

An issue installing the policy due to a possible

duplicate hash

Broadcom ACL x not found in internal table Attempting to delete a non-existent ACL

Broadcom ACL internal table overflow Attempting to add an ACL to a full table

Broadcom In hapiBroadQosCosQueueConfig, Failed to

configure minimum bandwidth. Available

bandwidth x

Attempting to configure the bandwidth beyond

it’s capabilities

Broadcom USL: failed to put sync response on queue A response to a sync request was not

enqueued. This could indicate that a previous

sync request was received after it was timed

out

Broadcom USL: failed to sync ipmc table on unit=x Either the transport failed or the message was

dropped

Broadcom usl_task_ipmc_msg_send(): failed to send

with x

Either the transport failed or the message was

dropped

Broadcom USL: No available entries in the STG table The Spanning Tree Group table is full in USL

Broadcom USL: failed to sync stg table on unit=x Could not synchronize unit x due to a transport

failure or API issue on remote unit. A

synchronization retry will be issued

Broadcom USL: A Trunk doesn't exist in USL Attempting to modify a Trunk that doesn’t exist

Broadcom USL: A Trunk being created by bcmx already

existed in USL

Possible synchronization issue between the

application, hardware, and sync layer

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 372 373

Comentários a estes Manuais

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 346

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Kontron AT8404 CLI