Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 296)

Management Commands AT8404

AT8404 CLI Reference Manual Page 5 - 20

5.7.14 passwords lock-out

Use this command to strengthen the security of the switch by locking user accounts that have failed login due to

wrong passwords. When a lockout count is configured, a user that is logged in must enter the correct password

within that count. Otherwise the user will be locked out from further switch access. Only a user with read/write access

can re-activate a locked user account. Password lockout does not apply to logins from the serial console. The valid

range is 1-5. The default is 0, or no lockout count enforced.

5.7.14.1 no passwords lock-out

Use this command to set the password lock-out count to the default value.

5.7.15 show passwords configuration

Use this command to display the configured password management settings.

5.7.16 write memory

Use this command to save running configuration changes to NVRAM so that the changes you make will persist

across a reboot. This command is the same as copy system:running config nvram:startup-config.

5.8 SNMP Commands

This section describes the commands you use to configure Simple Network Management Protocol (SNMP) on the

switch. You can configure the switch to act as an SNMP agent so that it can communicate with SNMP managers on

your network.

Default 0

Format passwords lock-out <1-5>

Mode Global Config

Format no passwords lock-out

Mode Global Config

Format show passwords configuration

Mode Privileged EXEC

Term Definition

Minimum

Password Length

Minimum number of characters required when changing passwords.

Password History Number of passwords to store for reuse prevention.

Password Aging Length in days that a password is valid.

Lockout Attempts Number of failed password login attempts before lockout.

Format write memory

Mode Privileged EXEC

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 372 373

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 296