Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 50)

Switching Commands AT8404

AT8404 CLI Reference Manual Page 2 - 14

to 61440. The twelve least significant bits are masked according to the 802.1s specification. This causes the priority

to be rounded down to the next lower valid priority.

2.2.17.1 no spanning-tree mst priority

This command sets the bridge priority for a specific multiple spanning tree instance to the default value. The

parameter <mstid> is a number that corresponds to the desired existing multiple spanning tree instance.

If 0 (defined as the default CIST ID) is passed as the <mstid>, this command sets the Bridge Priority parameter for

the common and internal spanning tree to the default value.

2.2.18 spanning-tree mst vlan

This command adds an association between a multiple spanning tree instance and one or more VLANs so that the

VLAN(s) are no longer associated with the common and internal spanning tree. The parameter <mstid> is a

number that corresponds to the desired existing multiple spanning tree instance. The vlan range can be specified

as a list or as a range of values. To specify a list of VLANs, enter a list of VLAN IDs, each separated by a comma

with no spaces in between. To specify a range of VLANs, separate the beginning and ending VLAN ID with a dash

("-").

2.2.18.1 no spanning-tree mst vlan

This command removes an association between a multiple spanning tree instance and one or more VLANs so that

the VLAN(s) are again associated with the common and internal spanning tree.

2.2.19 spanning-tree port mode

This command sets the Administrative Switch Port State for this port to enabled.

Default 32768

Format spanning-tree mst priority

Mode Global Config

Format no spanning-tree mst priority

<mstid>

Mode Global Config

Format spanning-tree mst vlan <mstid> <vlanid>

Mode Global Config

Format no spanning-tree mst vlan <mstid> <vlanid>

Mode Global Config

Default disabled

Format spanning-tree port mode

Mode Interface Config

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 372 373

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 50