Kontron AT8404 CLI Manual do Utilizador descarregar pdf (Página 219)

AT8404 Utility Commands

Page 4 - 5 AT8404 CLI Reference Manual

4.3.5.1 no ekeying all (configure)

This command disables the ekeying for all ports for which ekeying is possible.

4.4 System Information and Statistics Commands

This section describes the commands you use to view information about system features, components, and

configurations.

4.4.1 show arp switch

This command displays the contents of the IP stack’s Address Resolution Protocol (ARP) table. The IP stack only

learns ARP entries associated with the management interfaces - network or service ports. ARP entries associated

with routing interfaces are not listed.

4.4.2 show eventlog

This command displays the event log, which contains error messages from the system. The event log is not cleared

on a system reset.

Format no ekeying all

Mode Global Config

Format show arp switch

Mode Privileged EXEC

Term Definition

IP Address IP address of the management interface or another device on the management network.

MAC Address Hardware MAC address of that device.

Interface For a service port the output is Management. For a network port, the output is the slot/port of

the physical interface.

Format show eventlog

Mode Privileged EXEC

Term Definition

File The file in which the event originated.

Line The line number of the event.

Task Id The task ID of the event.

Code The event code.

Time The time this event occurred.

Note: Event log information is retained across a switch reset.

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 372 373

Sem comentários

Kontron AT8404 CLI Manual do Utilizador Página 219