Kontron AT8902M CLI Manual do Utilizador descarregar pdf (Página 275)

AT8902M Management Commands

Page 6 - 23 AT8902M CLI Reference Manual

6.6.21 show snmptrap

This command displays SNMP trap receivers. Trap messages are sent across a network

to an SNMP Network Manager. These messages alert the manager to events occurring

within the switch or on the network. Six trap receivers are simultaneously supported.

Format show snmptrap

Mode Privileged EXEC

SNMP Trap Name The community string of the SNMP trap packet sent to the trap

manager. The string is case sensitive and can be up to 16 alphanumeric

characters.

IP Address The IP address to receive SNMP traps from this device.

Status The receiver's status (enabled or disabled).

6.6.22 show trapflags

This command displays trap conditions. Configure which traps the switch should

generate by enabling or disabling the trap condition. If a trap condition is enabled and

the condition is detected, the SNMP agent on the switch sends the trap to all enabled

trap receivers. You do not have to reset the switch to implement the changes. Cold and

warm start traps are always generated and cannot be disabled.

Format show trapflags

Mode Privileged EXEC

Authentication Flag Can be enabled or disabled. The factory default is enabled. Indi-

cates whether authentication failure traps will be sent.

Link Up/Down Flag Can be enabled or disabled. The factory default is enabled. Indi-

cates whether link status traps will be sent.

Multiple Users Flag Can be enabled or disabled. The factory default is enabled. Indi-

cates whether a trap will be sent when the same user ID is logged into

the switch more than once at the same time (either through Telnet or

the serial port).

Spanning Tree Flag Can be enabled or disabled. The factory default is enabled. Indi-

cates whether spanning tree traps are sent.

ACL Traps May be enabled or disabled. The factory default is disabled. Indicates

whether ACL traps are sent.

DVMRP Traps Can be enabled or disabled. The factory default is disabled. Indicates

whether DVMRP traps are sent.

OSPF Traps Can be enabled or disabled. The factory default is disabled. Indicates

whether OSPF traps are sent.

PIM Traps Can be enabled or disabled. The factory default is disabled. Indicates

whether PIM traps are sent.

6.7 CLI Command Logging Command

This section describes the commands you use to configure CLI Command Logging.

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 314 315

Sem comentários

Kontron AT8902M CLI Manual do Utilizador Página 275