Kontron AT8902M CLI Manual do Utilizador Página 103
- Página / 315
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
AT8902M Switching Commands
Page 2 - 67 AT8902M CLI Reference Manual
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap Mode Whether violation traps are enabled.
2.16.7 show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format
show port-security dynamic <slot/port>
Mode Privileged EXEC
MAC Address MAC Address of dynamically locked MAC.
2.16.8 show port-security static
This command displays the statically locked MAC addresses for port.
Format
show port-security static <slot/port>
Mode Privileged EXEC
MAC Address MAC Address of statically locked MAC.
2.16.9 show port-security violation
This command displays the source MAC address of the last packet discarded on a
locked port.
Format
show port-security violation <slot/port>
Mode Privileged EXEC
MAC Address MAC Address of discarded packet on locked port.
2.17 LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery
Protocol (LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows
stations on an 802 LAN to advertise major capabilities and physical descriptions. The
advertisements allow a network management system (NMS) to access and display this
information.
2.17.1 lldp transmit
Use this command to enable the LLDP advertise capability.
Default disabled
Format
lldp transmit
Mode Interface Config
2.17.1.1 no lldp transmit
Use this command to return the local data transmission capability to the default.
- AT8902M CLI Reference Manual 1
- AdvancedTCA 1
- AT8902M Preface 2
- Table of Contents 3
- Table of Contents AT8902M 10
- AT8902M Table of Contents 11
- Appendix 19
- Preface AT8902M 22
- 1.1 Command Syntax 28
- 1.2 Command Conventions 28
- 1.2.1 Common Parameter Values 29
- 1.5 Command Modes 31
- 1.5.2 CLI Error Messages 34
- 1.6 Using CLI Help 35
- 1.7 Accessing the CLI 36
- Switching Commands 37
- 2. Switching Commands 38
- Switching Commands AT8902M 100
- AT8902M Switching Commands 101
- Routing Commands 115
- Chapter 1 115
- 3. Routing Commands 116
- AT8902M Routing Commands 117
- Routing Commands AT8902M 118
- Quality of Service Commands 169
- 4.1.3 classofservice trust 171
- [<slot/port>] 174
- 4.2.1 diffserv 175
- 4.3 DiffServ Class Commands 176
- 4.3.2 class-map rename 177
- 4.3.3 match ethertype 177
- 4.3.4 match any 177
- 4.3.5 match class-map 177
- 4.3.5.1 no match class-map 178
- 4.3.6 match cos 178
- 4.3.7 match secondary-cos 178
- 4.3.9 match dstip 179
- 4.3.10 match dstl4port 179
- 4.3.11 match ip dscp 179
- 4.3.12 match ip precedence 179
- 4.3.13 match ip tos 180
- 4.3.14 match protocol 180
- 4.3.16 match srcip 181
- 4.3.17 match srcl4port 181
- 4.3.18 match vlan 181
- 4.4 DiffServ Policy Commands 182
- 4.4.2 drop 183
- 4.4.3 mirror 183
- 4.4.4 redirect 183
- 4.4.5 conform-color 183
- 4.4.6 class 183
- 4.4.6.1 no class 184
- 4.4.7 mark cos 184
- 4.4.8 mark ip-dscp 184
- 4.4.9 mark ip-precedence 184
- 4.4.10 police-simple 185
- 4.4.11 policy-map 185
- 4.4.11.1 no policy-map 185
- 4.5 DiffServ Service Commands 186
- 4.6 DiffServ Show Commands 187
- 4.6.2 show diffserv 188
- 4.6.3 show policy-map 188
- 4.6.4 show diffserv service 190
- 4.6.7 show service-policy 191
- 4.7.3 {deny 192
- 4.7.4 mac access-group 194
- 4.7.4.1 no mac access-group 194
- 4.7.5 show mac access-lists 194
- 4.8.1 access-list 195
- 4.8.1.1 no access-list 196
- 4.8.2 ip access-group 197
- 4.8.2.1 no ip access-group 197
- 4.8.3 acl-trapflags 197
- 4.8.3.1 no acl-trapflags 197
- 4.8.4 show ip access-lists 197
- 4.8.5 show access-lists 198
- 4.9 ACL trap commands 199
- Utility Commands 201
- 5. Utility Commands 202
- AT8902M Utility Commands 203
- Utility Commands AT8902M 204
- Management Commands 253
- 6. Management Commands 254
- AT8902M Management Commands 255
- Management Commands AT8902M 256
- Getting Help 289
- A. Getting Help 290
- AT8902M Getting Help 291
- Getting Help AT8902M 292
- (if not under warranty) 293
- List of Commands 295
- B. List of Commands 296
- AT8902M List of Commands 297
- List of Commands AT8902M 298
Manuais e produtos relacionados com Hardware Kontron AT8902M CLI
Hardware Kontron AT8904 Manual do Utilizador
(93 páginas)
(93 páginas)
Hardware Kontron AT8904 CLI Manual do Utilizador
(317 páginas)
(317 páginas)
Hardware Kontron AT8940 Manual do Utilizador
(84 páginas)
(84 páginas)
Hardware Kontron RTM8940 Manual do Utilizador
(36 páginas)
(36 páginas)
Hardware Kontron AT8402 CLI Manual do Utilizador
(253 páginas)
(253 páginas)
Hardware Kontron AT8404 Manual do Utilizador
(132 páginas)
(132 páginas)
Hardware Kontron AT8404 CLI Manual do Utilizador
(373 páginas)
(373 páginas)
Hardware Kontron RTM8050 Manual do Utilizador
(37 páginas)
(37 páginas)
Hardware Kontron AT8050 Manual do Utilizador
(165 páginas)
(165 páginas)
Hardware Kontron RTM8242 Manual do Utilizador
(34 páginas)
(34 páginas)
Hardware Kontron AT8242 Manual do Utilizador
(109 páginas)
(109 páginas)
Hardware Kontron AT8060 Manual do Utilizador
(160 páginas)
(160 páginas)
Hardware Kontron RTM806x Manual do Utilizador
(40 páginas)
(40 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.073 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais