Kontron NSC2U IP Network Server Manual do Utilizador descarregar pdf (Página 111)

Kontron IP Network Server NSC2U

December 2009 Product Guide, rev. 1.4

111

The drive bay assembly is also removed if the SAS backplane board or Power

Distribution Board (PDB) module need to be replaced.

Caution: Before replacing any of the boards in the NSC2U Server, you must first take the server

out of service, turn off all peripheral devices connected to the system, turn off the

system by pressing the power button, and unplug the power cord(s) from the system

or wall outlet.

5.4.1 Removing the Drive Bay Assembly

1. Disconnect the following cables that are attached to the SAS backplane board at

the rear of the drive bay assembly:

—flex cable

— power cable from the SFP board

— IDE cable from the server board

2. Remove the three screws that attach the drive bay front panel to the side of the

chassis. (Figure 97, “A”)

3. Remove the two screws on the right side of the drive bay front panel that attach it

to the chassis front panel. (“B”)

4. Pull the drive bay assembly out of the chassis. (“C”)

Figure 97. Removing the Drive Bay Assembly

TS000313

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 151 152

Sem comentários

Kontron NSC2U IP Network Server Manual do Utilizador Página 111