Kontron AT8901M CLI Manual do Utilizador descarregar pdf (Página 275)

AT8901M Management Commands

Page 6 - 23 AT8901M CLI Reference Manual

DVMRP Traps

Can be enabled or disabled. The factory default is disabled. Indicates

whether DVMRP traps are sent.

OSPF Traps Can be enabled or disabled. The factory default is disabled. Indicates

whether OSPF traps are sent.

PIM Traps Can be enabled or disabled. The factory default is disabled. Indicates

whether PIM traps are sent.

6.7 CLI Command Logging Command

This section describes the commands you use to configure CLI Command Logging.

6.7.1 logging cli-command

This command enables the CLI command logging feature, which enables the

FASTPATH software to log all CLI commands issued on the system.

Default enabled

Format logging cli-command

Mode Global Config

6.7.1.1 no logging cli-command

This command disables the CLI command Logging feature.

Format no logging cli-command

Mode Global Config

6.8 RADIUS Commands

This section describes the commands you use to configure the switch to use a Remote

Authentication Dial-In User Service (RADIUS) server on your network for

authentication and accounting.

6.8.1 radius accounting mode

This command is used to enable the RADIUS accounting function.

Default disabled

Format radius accounting mode

Mode Global Config

6.8.1.1 no radius accounting mode

This command is used to set the RADIUS accounting function to the default value - i.e.

the RADIUS accounting function is disabled.

Format no radius accounting mode

Mode Global Config

6.8.2 radius server host

This command is used to configure the RADIUS authentication and accounting server.

If you use the <auth> parameter, the command configures the IP address to use to

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 312 313

Sem comentários

Kontron AT8901M CLI Manual do Utilizador Página 275