Kontron NSW1U IP Network Server Manual do Utilizador descarregar pdf (Página 27)

Kontron IP Network Server NSW1U

December 2009 Product Guide, rev. 1.4

Server Installations and Upgrades—NSW1U Network Server

3.2.4 Installing the Front Bezel

1. While holding the front bezel in place, tighten the screws at the left and right edges of the bezel.

3.2.5 Removing the Processor Air Duct

The air duct must be removed to access the processor assembly and the fan assembly. The processor

air duct is required for proper airflow within the chassis. Be sure the air duct is in place before

installing the chassis cover.

1. Power down the server system and unplug all peripheral devices and the power cord.

2. Remove the chassis cover. For instructions, see Section 3.2.1, “Removing the Chassis Cover” on

page 25.

3. Remove the screws at the top of the air duct (Figure 14, “A”).

4. Lift the air duct from the server platform (“B”).

Figure 13. Removing the Front Bezel

AF000875

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 109 110

Sem comentários

Kontron NSW1U IP Network Server Manual do Utilizador Página 27