Kontron VMP1 with Netbootloader Manual do Utilizador descarregar pdf (Página 108)

VMP1 VMP1-IO1 Module (Optional)

ID 26037, Rev. 01Page A - 12 ® 2002 PEP Modular Computers GmbH

HJumper Setting

The jumper settings of the IO1 module depend on the module’s position relative to the

VMP1 and other modules, if any (please see Figure A4 below).

Table A4: IO1 Jumper Settings for Different Module Positions

Figure A-4: Cascading of IO1 (or other) Modules onto the VMP1

IDSEL Clock GNT# REQ#

J12J11J10J1J2J3J4J5J6J7J8J9

Position 1 Set Open Open Set Open Open Set Open Open Set Open Open

Position 2 Open Set Open Open Set Open Open Set Open Open Set Open

Position 3 Open open Set Open Open Set Open Open Set Open Open Set



Note:

Position 1 refers to the settings applicable when 1 module (IO1 or

other) is attatched to the VMP1.

Position 2 refers to the settings applicable when 2 modules (IO1

or other) are attatched to the VMP1.

Position 3 refers to the settings applicable when 3 modules (IO1

or other) are attatched to the VMP1.

Important!

: Position 3 has not yet been tested and approved by

PEP and is not recommended for use in this issue of the manual.

KEY

: 1 additional module

P2: 2 additional modules

: 3 additional modules

P3 has not yet been tested and

approved by PEP and is intended

for possible future use.

VMP1

WUH

ABRST

LNK.

SPEEDACT.

VMP1-IO1

or other

module

VMP1-IO1

or other

module

P1 P2 P3

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 119 120

Sem comentários

Kontron VMP1 with Netbootloader Manual do Utilizador Página 108