Kontron CP3-CMM1 Manual do Utilizador descarregar pdf (Página 3)

Operating Instructions Chassis Monitoring Module (CP3-CMM1)

31.01.2003, D0.5 3

 Digital Inputs

16 freely selectable digital input signals.

The following table shows the default assignment

of the digital inputs. This assignment and status

(active low/high) can be modified in the

configuration mode of the CMM (see chapter5).:

Input Default R96

pin

Default assigned

to

User defined

assignement

possible

DIN0 SYSFAILin A9 SYSFAIL_out /

OUT5

Yes

DIN1 FALin1 C2

DIN2 FALin2 C3

Yes

DIN3 FALin3 C4

DIN4 FALin4 C5

FAL_out / OUT9

OR-wired

Yes

DIN5 DEGin1 C6 Yes

DIN6 DEGin2 C7 Yes

DIN7 DEGin3 C8 Yes

DIN8 DEGin4 C9

DEG_out / OUT8

OR-wired

Yes

DIN9 HA_A0 C15 No

DIN10 HA_A1 C16 No

DIN11 HA_A2 C17 No

DIN12 HA_A3 C18 No

DIN13 HA_A4 C19

No assignment to

digital output

No

DIN14 AC-fail1 C11

DIN15 AC-fail2 C12

AC-fail_out / OUT4

OR-wired

Yes

 SYSRESET digital Input

The SYSRESET is connected as Input/Output. In

the Input mode it can be assigned to switch a digital

output.

Outputs Signals

 LED display

6 LEDs can be directly connected to the LED

outputs:

4 two colored LEDs (red/green), for +3.3V, +5V,

±12V OK/out-of-tolerance indication.

2 red LEDs for fault indication of “Fan Fail” and

“Temp Fail” signals (fail=LED on, OK=LED off)

There are no LED’s or other optical or acoustic

signal indicators mounted on the front panel or

the module itself.

 Digital Outputs

10 digital output signals are available:

• 4 open-collector output signals isolated

by opto-couplers:

• 6 TTL-compatible non-isolated signals:

The following table shows the default

assignment of the digital outputs. This

assignment and status (active low/high) can be

modified in the configuration mode of the CMM

(see chapter5).

output Default-assignment Type R96 pin

OUT0 Braking of sensor wire Optocoupler

Output

A13 / A14

OUT1 Temperature failure

CMM

Optocoupler

Output

A15 / A16

OUT2 Temperature failure

FCM

Optocoupler

Output

A17 / A18

OUT3 Fan Fail_out Optocoupler

Output

A19 / A20

OUT4 AC-fail_out TTL-Output A22

OUT5 SYSFAIL_out TTL-Output A23

OUT6 V5 (+24V) out of

tolerance

TTL-Output A24

OUT7 V6 (-24V) out of

tolerance

TTL-Output A25

OUT8 DEG_out TTL-Output A11

OUT9 FAL_out TTL-Output B27

TTL-Input-

Logic

+5V

10k

GND

+5V

10k

SYSRESET

TTL-Input-

Logic

High impedance = 1

Low impedance = 0

+5V

10k

+5V = 1

GND = 0

1 2 3 4 5 6 7 8 9 10

Comentários a estes Manuais

Sem comentários