Kontron MOPSlcdLX Manual do Utilizador descarregar pdf (Página 27)

KTD-S0005-C Page 23 Floppy Drive Interface

MOPSlcdLX User's Guide

14 Floppy Drive Interface

The floppy drive interface of the MOPSlcdLX uses a 2.88 MB Super-I/O floppy disk controller and can sup-

port one floppy disk drive with densities that range from 360 kB to 2.88 MB. The controller is 100% IBM

compatible.

14.1 Connector

The floppy disk interface is available on the flat-foil connector X15003 (26 pins). This type of connector is

often internally used in notebooks to connect a floppy drive.

Accessories are available for this interface from KONTRON. To connect a standard 3.5” floppy drive use an

adapter cable (ADA-FLOPPY-2, part number 96001-0000-00-0). If you have a slim-line 3.5” floppy drive you

may need a flat-foil cable (KAB-FLOPPY/ MOPS-1, part number 96019-0000-00-0). It also is possible to get

a slim-line 3.5” floppy drive with cable (FLOPPY-MOPS-1, part number 96010-0000-00-0).

Header Pin Signal Name Function Pin Signal Name Function

VCC

Power +5V 2 /IDX Index

VCC

Power +5V 4 /DR0 Drive select 0

VCC

Power +5V 6 /DSKCHG Disk change

7 N.C. Not connected 8 N.C. Not connected

9 N.C. Not connected 10 /MTR0 Motor on 0

11 N.C. Not connected 12 /FDIR Direction select

13 N.C. Not connected 14 /STEP Step

15 GND Ground 16 /WDATA Write data

17 GND Ground 18 /WGATE Write gate

19 GND Ground 20 /TRK0 Track 0

21 GND Ground 22 /WRTPRT Write protect

23 GND Ground 24 /RDATA Read data

25 GND Ground 26 /HDSEL Side one select

Note: 1) To protect the external power lines of peripheral devices make sure that

- the wires have the right diameter to withstand the maximum available current.

- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 53 54

Sem comentários

Kontron MOPSlcdLX Manual do Utilizador Página 27