Kontron KTH81-mITX Manual do Utilizador descarregar pdf (Página 43)

KTD-N0882-H Page 43 Internal Connectors

KTQ87/KTH81 Users Guide

7.6 SATA (Serial ATA) Disk interface

KTQ87 / KTH81 has integrated SATA Host controller (PCH in the Q87 / H81 chipset) which supports

independent DMA operation on 6 / 4 ports. One device can be installed on each port, via point-to-point

interface (SATA cable), for a maximum of 6 / 4 SATA devices. On the mITX the SATA ports are available as 5

/ 3 SATA connectors + 1 mSATA connector and on the Flex the SATA ports are available as 6 / 4 SATA

connectors.

All the SATA ports on the Q87 support SATA Gen3 (6.0/3.0/1.5Gb/s) are supported, while two SATA ports

on the H81 supports Gen3 and the remaining two ports support Gen2 (3.0/1.5Gb/s).

Note: Before installing OS on a SATA drive make sure the drive is not a former member of a RAID system. If

so some hidden data on the disk has to be erased. To do this, connect two SATA drives and select RAID in

BIOS. Save settings and select <Ctrl> <I> while booting to enter the RAID setup menu. Now the hidden

RAID data will be erased from the selected SATA drive.

Note: KTH81 do not support RAID.

The SATA controller supports:

2 to 6-drive RAID 0 (data striping)

2-drive RAID 1 (data mirroring)

3 to 6-drive RAID 5 (block-level striping with parity).

4-drive RAID 10 (data striping and mirroring)

2 to 6-drive matrix RAID, different parts of a single drive can be assigned to different RAID devices.

AHCI (Advanced Host Controller Interface)

NCQ (Native Command Queuing). NCQ is for faster data access.

Swap bay support (not supported on mSATA)

Intel® Rapid Recover Technology

2 – 256TB volume (Data volumes only)

Capacity expansion

TRIM in Windows 7 (in AHCI and RAID mode for drives not part of a RAID volume). (TRIM is for SSD data

garbage handling).

Sata connector pinning: SATA0, SATA1, SATA2, SATA3, SATA4 and SATA5. (SATA1 used by mSATA on mITX)

PIN Signal Type Ioh/Iol Note

1 GND PWR -

2 SATA* TX+

3 SATA* TX-

4 GND PWR -

5 SATA* RX-

6 SATA* RX+

7 GND PWR -

Signal Description

SATA* RX+ / RX- Host transmitter differential signal pair

SATA* TX+ / TX-

Host receiver differential signal pair

“*” specifies 0, 1, 2, 3, 4, 5 depending on SATA port.

Available cable kit:

PN 821035 Cable SATA 500mm

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 97 98

Comentários a estes Manuais

Sem comentários

Kontron KTH81-mITX Manual do Utilizador Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Kontron KTH81-mITX