Kontron CP-RIO3-04S Manual do Utilizador descarregar pdf (Página 38)

Installation CP-RIO3-04S

Page 3 - 6 ID 1036-1669, Rev. 1.0

3.4 Installation of External Serial ATA Devices

Up to two external SATA devices may be connected to the CP-RIO3-04S via the onboard SATA

connectors J5 and J6 as well as the appropriate SATA cables.

Some symptoms of incorrectly installed SATA devices are:

• Device on a SATA channel does not spin up: check power cables and cabling. May also

result from a bad power supply or SATA device.

The SATA connector on the CP-RIO3-04S provides only a data connection. The power

for this device must be supplied by a separate connector. For further information, refer

to the respective documentation of the device.

• SATA device fail message at boot-up: may be a bad cable or lack of power going to the

drive.

Warning!

The incorrect connection of power or data cables may damage the SATA

device and/or the CP-RIO3-04S.

1 2 ... 33 34 35 36 37 38

Sem comentários

Kontron CP-RIO3-04S Manual do Utilizador Página 38